Tips

Surgical Pearls in Total Knee Arthroplasty: A Lifetime of Lessons Learned

Am J Orthop. 2016 September;45(6):384-388

Total knee arthroplasty (TKA) has evolved into a very successful procedure to relieve pain and improve function in the patient with advanced arthritis. Both short- and long-term outcomes are dependent on optimal surgical technique. In this article, I share a few of the many lessons learned over more than 40 years of experience performing TKA regarding exposure, alignment, bone preparation, correction of deformity, and prosthetic implantation.

PDF Download

References

1. Yacoubian SV, Scott RD. Skin incision translation in total knee arthroplasty: the difference between flexion and extension. J Arthroplasty. 2007;22(3):353-355.

2. Schai PA, Gibbon AJ, Scott RD. Kneeling ability after total knee arthroplasty. Perception and reality. Clin Orthop Relat Res. 1999;367:195-200.

3. Springorum HP, Scott RD. A technique to facilitate everting the patella in stiff or obese knees in total knee arthroplasty. Am J Orthop. 2009;38(10):507-508.

4. Scott RD. Total Knee Arthroplasty. 2nd ed. Philadelphia, PA: Elsevier; 2014.

5. Dixon MC, Parsch D, Brown RR, Scott RD. The correction of severe varus deformity in total knee arthroplasty by tibial component downsizing and resection of uncapped proximal medial bone. J Arthroplasty. 2004;19(1):19-22.

6. Mullaji AB, Padmanabhan V, Jindal G. Total knee arthroplasty for profound varus deformity: technique and radiological results in 173 knees with varus of more than 20 degrees. J Arthroplasty. 2005;20(5):550-561.

7. Politi J, Scott RD. Balancing severe valgus deformity in total knee arthroplasty using a lateral cruciform retinacular release. J Arthroplasty. 2004;19(5):553-557.

8. Huddleston JI, Wiley JW, Scott RD. Zone 4 femoral radiolucent lines in hybrid versus cemented total knee arthroplasties: are they clinically significant? Clin Orthop Relat Res. 2005;441:334-339.

9. Lee DC, Kim DH, Scott RD, Suthers K. Intraoperative flexion against gravity as an indication of ultimate range of motion in individual cases after total knee arthroplasty. J Arthroplasty. 1998;13(5):500-503.

After over 4 decades of experience with total knee arthroplasty (TKA), I have learned many lessons regarding surgical technique. These include exposure issues, alignment methods, bone preparation, correction of deformity, and implantation techniques. Most of these lessons have been self-taught, but some have been suggested by or modified from colleague and student interaction. Attribution is given when possible.

The Incision

The skin incision should be marked in flexion rather than extension because the skin moves approximately 1 cm laterally from extension to flexion.¹ This occurs because the tibia internally rotates beneath the skin as the knee is flexed and externally rotates as full extension is achieved. This lateral movement of the skin could bring an incision marked in extension on top of the tibial tubercle when the knee is flexed and may result in pain and dysfunction when the patient attempts to kneel. A review of kneeling ability after TKA showed that most patients are hesitant to kneel initially after their arthroplasty, but gain confidence and improved comfort and ability as their scar matures.²

Exposure

Patellar eversion can be difficult in a markedly obese or ankylosed knee, especially when the patella is difficult to grasp. This is facilitated by the use of a standard patellar clamp that is normally used to compress the patella during component cementation (Figure 1).³

Figure 1.

When using this technique, remember to protect the patellar tendon from avulsion by using the techniques described below.

Exposing the Ankylosed Knee and Protecting the Patellar Tendon From Avulsion

A tibial tubercle osteotomy is often recommended in the ankylosed knee but can be avoided by making a short inverted “V” incision in the proximal quadriceps tendon (Figure 2).⁴

Figure 2.

This maneuver, along with a smooth 1/8-inchpin in the tibial tubercle, also protects the patellar tendon from avulsing (Figure 3).

Figure 3.

The patella can be easily everted and access to the lateral parapatellar scar tissue allows a lateral release to be performed from inside out to further mobilize the knee and enhance exposure. The inverted “V” incision can be closed anatomically, and no modifications of the postoperative physical therapy program are necessary.

Protecting the Soft Tissues During Surgery

Moist wound towels sewn into the joint capsule protect the underlying soft tissues from debris and desiccation during the procedure and will intuitively lower the chance of wound infection from contamination and tissue injury (Figures 4A, 4B).

Figure 4.

Since I have done this routinely in both hip and knee arthroplasty over the last 7000 consecutive primary arthroplasties, I have had no operative deep infections. This experience is without the use of antibiotics in the bone cement.

Locating and Coagulating the Lateral Inferior Genicular Vessels

The lateral inferior genicular artery and vein can be easily located and coagulated just outside the posterior rim of the lateral meniscus near the popliteus hiatus. This will minimize both intraoperative and postoperative blood loss.

Determining the Entry Point in the Distal Femur for Intramedullary Alignment Devices

Templating the femoral entry point for insertion of an intramedullary alignment device on a preoperative radiograph will help avoid inadvertent excessive distal femoral valgus resection. This is especially important in valgus knees that have a valgus metaphyseal bow (Figure 5).

Figure 5.

In these cases, the entry point must be moved medially and/or the valgus angle chosen must be diminished.

Avoiding Notching of the Anterior Femoral Cortex

Notching the anterior femoral cortex when in-between femoral sizes or when there is a preexisting dysplastic or shallow trochlea (Figure 6)

Figure 6.

can be avoided by making the distal femoral resection in an extra 3° of flexion. In most TKA systems, the prosthetic trochlear flange diverges 3° or 4° away from the posterior femoral condyles. If the distal femoral resection is made in an extra 3° of flexion, the femoral component utilized can be anatomically sized off the patient’s posterior femoral condyles and the diverging trochlear flange will avoid notching the anterior femoral cortex while providing increased surface contact with the trochlear bone, enhancing prosthetic fixation. The only potential adverse effects of increased femoral component flexion would occur in a system that does not allow hyperextension of the femoral/tibial articulation without loss of articular contact or in a posterior-stabilized articulation where there could be post impingement in hyperextension. Total knee systems vary in the amount of hyperextension that can be tolerated.

Obtaining a Medial Release by Removing Peripheral Medial Tibial Bone

Varus deformities can be corrected without performing a formal medial collateral ligament (MCL) release by a so-called reduction tibial osteotomy.^5,6 In mild varus deformity, sufficient medial release can be achieved by removing medial femoral and tibial peripheral osteophytes that tent up the MCL and medial capsule. When this is insufficient, removal of additional peripheral tibial bone further shortens the distance between the origin and insertion of the MCL, effectively lengthening the ligament (Figure 7).

Study Identifies Two Biomarkers That Contribute to Spine Osteoarthritis